THIS SNOWPACK SUMMARY EXPIRED ON December 25, 2015 @ 12:28 pm
Snowpack Summary published on December 24, 2015 @ 7:28 pm
Issued by Ben Bernall - Kootenai National Forest
Avalanche Character 1: Storm Slab
Storm Slab avalanches release naturally during snow storms and can be triggered for a few days after a storm. They often release at or below the trigger point. They exist throughout the terrain. Avoid them by waiting for the storm snow to stabilize.

Todays compression tests and travels revealed that recent storm snow has bonded poorly to the existing snowpack.  This layer is most concerning on steep, windloaded aspects above 35 degrees.  Backcountry travelers should exercise caution on all wind loaded and convex terrain features.  Keep a watchful eye for "pillows" forming on the leeward side of all ridgelines.

Avalanche Character 2: Persistent Slab
Persistent Slab avalanches can be triggered days to weeks after the last storm. They often propagate across and beyond terrain features that would otherwise confine Wind and Storm Slab avalanches. In some cases they can be triggered remotely, from low-angle terrain or adjacent slopes. Give yourself a wide safety buffer to address the uncertainty.

Extended column tests revealed failure below the December 9th rain crust with hard force (ECTP21).  This layer failed on weak faceted snow and propagated through the column with a quality 2 shear.  This layer is found on all aspects above 5,000' elevation and varies in depth (2-4' below surface) and thickness throughout the Kootenai N.F.  Although this weak layer is not highly reactive it should be treated with caution considering the additional loading brought on by the last 7 days of fairly continuous snowfall. Once again, it is essential to choose conservative terrain and avoid steep, windloaded slopes where this layer is more likely to be reactive to a human trigger.

Snowpack Discussion

This snowpack summary will be issued once weekly on Thursday afternoons.  Questions regarding this summary may be sent to bbernall@fs.fed.us

Public snowpack and avalanche observations from the Kootenai area are both needed and strongly encouraged. This information sharing is highly valuable in improving the safety of winter backcountry users.  Please see FAC Observation page for information on submitting public observations (here).

recent observations

Today I traveled to Flatiron Mountain in the Purcell range where I dug a pit on a north aspect at 6,100'.  Compression tests revealed easy failure within the top 6 inches of the snowpack at the new/old snow interface.  This same layer could be found cracking on wind loaded features but showing very little propensity to produce momentum.  Deeper in the snowpack the extended column test failed with hard force below the December 9th rain crust on weak faceted snow.  Below this layer no failures were noted, however; the bottom 4" of the snowpack consisted of larger (2-3mm) faceted grains.

Travels in the Eastern Cabinets on December 19th showed that this weakness below the crust also failed with hard force (ECTP24) and propagated across the column with a quality 2 shear.  This crust layer and the surrounding snowpack was much thicker in the Cabinet region in comparison to the Purcell Mountains. 

Weather and CURRENT CONDITIONS
weather summary

National Weather Service predicts that snow showers will taper off into Christmas Day followed by the development of high pressure and stable atmospheric conditions early next week and cooler temperature moving into the Kootenai region.

Disclaimer

This summary applies only to backcountry areas outside established ski area boundaries. This summary describes general avalanche conditions and local variations always occur. The information in this summary is provided by the USDA Forest Service who is solely responsible for its content.